I have a SPA504G configured as an extension mobility but I need to add a SPA500S console to it.The p...

any solutions ???

i'm having the same problem, did you find out a solution??

helloi'm using a rv042 with Cisco ProtectLink enable behind another router (x.x.x.106)If I change th...

tell me what you want to see and i'll give yousorry i'm not a IOS specialist

how can i find why it fails

another strange thingIf i setup a softphone(x-lite) on my laptop with the same SIP trunk, then the c...

i put term mon with debug ccsip messages and nothing's showing

i've been able to register my sip trunk, I can make call and 2 way audio is ok but the problem is th...

here's my problemI have a UC500 configure in my lan network using WAN port (it's behind the router a...

Hi,i've installed the new firmware on my router and now the UC is showing 100% all the timeI've trie...

no didn't open a casei'm giving up on this router, many many many problems with it-vpn tunnel droppi...

Hi,we are looking to replace our old pix506e.we have 5-6 web servers.We would like to have a router ...

ok but you said this :Keep in mind that you probably can't just prioritize those on the WAN interfac...

would it be better if we would put the uc540 as the router/inter gateway thatn using it by the wan p...