Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a question about DCNM (in this case 11.4.1) with a vxlan switch fabric. If there were configuration changes deployed directly on the switch for endpoint devices and DCNM will get out of sync, with also interfaces which were before in a VPC / c...
The guide is not very clear on this but the ACL is working but for EWC or Flex you need some extra configuration, on EWC / Flexconnect there are two ways to configure an ACL:
- On the flexconnect profile attached to the vlan
- On the wlan
But for b...
we have the same issue with Mitel 5624 phones on a 5520 controller, 2802 AP's and version 8.2.151.0. What we can see in the wireless capture is after the SIP call setup the wireless handset is doing a SIP SDP request to the voice controller, it does ...
Hello Neville,Did you had any solution for this problem. we have the same issue with a customer and have 50 1131 access points disconnects from the 5508 controller when we unplug 1 3600 AP. the 50 access points failover to a 4404 controller and conne...
hello Mohammad,i've tested it with a foreign controller with 7.5 and 7.4. on the anchor controller i had all time 7.2.110.0 installed. with 7.5 apple tv screen sharing is working right away, when i install 7.4 it does not work. do you have also inst...
I've had the same challenge with a customer with apple tv and anchor controller. the only software capable of doing right now after testing is 7.5. I did'nt have the time to do in a in depth analysing with i think it indeed has something to do with m...
