Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm using a SPA-3102 in France for 1 year now without problem.Two days ago, I had to reset my device.after reconfiguring to connect to my PSTN and IPBX, I'm unable ti dial * or # on external line.It works perfectly if I connect a phone to my PSTN...
HI,I'm using a SPA-504G IP Phone, a SPA-3102 Gateway to my PSTN line, and a 3CX v10 IPBX. I'd like to store DTMF String in my phonebook... How can I do that?Example:To forward my line to my cellphone I have to dial 0 (for external line) then *21#I wo...
HI,I'm using a SPA-504G IP Phone, a SPA-3102 Gateway to my PSTN line, and a 3CX v10 IPBX. I'd like to store DTMF String in my phonebook... How can I do that?Example:To forward my line to my cellphone I have to dial 0 (for external line) then *21#I wo...
Hi,I had similar problem, my 3102 was not disconnecting when I finished my callsYou may have to change setting in Voice > PSTN Line > PSTN Disconnect Detection section Line "Disconnect Tone" I had to put 440@-30,440@-30;2(0.5/0.5/1+2) for france
Oups not a comma but a "P"Extract from PDF File p.204:For a pause, enter P followed by a number and a space. The duration of the pause is the specified number of seconds
Well paolo...according to the SPA5xx Administration Guide it is possible to store pauses in speedDials using a comma (,)page 204 in http://www.cisco.com/en/US/docs/voice_ip_comm/csbpipp/ip_phones/administration/guide/spa500_admin.pdf
