Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I would like to remove an object configured in ASDM by "asdm location 1.1.1.1 255.255.255.255 inside" command. Sadly, this object "1.1.1.1" stays in several NAT rules and access rules in the configuration so I can't remove this object because ...
Hi, I need to count the bytes for some interesting traffic crossing the firewall in ASA 5500. Packet Capture is so far as I need, cause I only need the number of bytes during a long time for about 3 months (source host - destination host)capture capi...
Please, could you help to know what would be the low cisco router (cheapest) that can be configured under BPG protocol (8xx, 17xx...)Thanks a lot from Spain,Andrew
Hi Jouni,thanks for your answer. I have tested "clear configure asdm location" in a testing appliance. When the object "1.1.1.1" stays in some access rule, "clear configure asdm location" command does nothing, all the config remains the same. But if ...
Thanks Javier for your answer, these commands are usefull when the session is tunneled or runs in VPN, but my traffic that I need to account is easier. For a simple ftp session between source - destination or icmp connection the "show crypto.." or "s...
Thanks Jouni for your answer and sorry for my explication, i'll try to make it better I need to count the number of bytes for an interesting traffic. I only need to know the number of cumulative bytes of that traffic, not to capture the packets in a ...
