Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I am facing a challenge with SPAN whenever i change speed to 1000mbps on my destination port , my interface status goes to down/down on my destination port (g1/0/23) but if i set it to 100mbps it works fine.i need to fix 1000 mbps, what do i ...
Thanks for your feedback. 1. if set to auto,it does not negotiate to 1000/full.2. I going to check my cable cause three pairs failed as per the tdr test as below.SwitchA#show cable-diagnostics tdr int g1/0/23TDR test last run on: September 23 14:08:...
