Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently have 2 ASA 5510s replicating. Last night I restarted the standby ASA but not it will no longer receive the configuration from the active ASA. This is been working fine for ages so not sure what is wrong. It begins configuration replication ...
Hi,Bare with me as I am not very technical and all very new to this, how I have got this far I will never know.But basically I have a cisco ASA5510 we had 1 public IP range on an outside interface but eventually I have now used all these IPs up so we...
Got the ISP to route the new subnet directly to the current ASA outside interface, noticed lots of packets being blocked for a very similar subnet.Turns out they had mistyped the subnet in the original email they sent me and so none of my solutions w...
Thanks I can only asume the problem is the ISP itself not routing the new range to my existing interface IP.Currently it's just ROUTER ------> FIREWALL and I am guessing their rules are just the subnets are out the router interface but not specifical...
Sorry I am pretty rubbish with the commands, only really understand the GUI interface, never done any networking before setting this up. Happy to use the method of using only the 1 interface. Have created PAT rules the same as before but no avail....
Hi,Thanks for the response. At the moment the second IP range is already being routed towards the ASA. Hence why I was just using the switch to try and split the 2 ranges.If I have read your response correctly all I really need to do is issue the com...
