Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two Cisco ASA 5540s that i want to cluster... here are the basic that I have covered thus far:Code is the same for both units, failover configs, and mgmt interfaces are up and up.I have not connected either FW to the network yet... should fail...
I have two external address that need to talk to each other.I know this does NOT require a VPN tunnel to do so and NAT is not needed either.I need to enable access on the outside interface for a public ip>(public IP that lives on my ASA <------------...
As mentioned:You have to set the priority of the switches and that will determine which one is the Master switch.If they are 3750s then 15 is highest priority; if 2960s set Master to priority 14.If the priorities are the same then the switch with the...
Issue was a faulty x-over cable... once i did that... the config sync occurred and i was able to test Active/Standby respectively for both units.Issue is RESOLVED.
Did not work... i blew away the failover configs and the int M0/0 configs too... and reapplied the configs minus the management-only on the interfaces still did not work.I connected both the Active/Standby and still wont detect each other.I also atte...
