Hi All, I'm studying for my CCNA, I'm currently in the later stages of ICND 1. My problem is IOS related and is as follows: As part of my network lab I have bought a reconditioned 2600 series routrer (2610XM), which, when it arrived was working just fine. However, something occured which seems to have corrupted the flash file, If I knew what then I would state it here, but I don't, I have a strong suspicion it may be the result of pulling the USB - DB9 out whilst the a connection was still active. Anyway, I am where I am. And that's stuck in ROMmon mode. I've checked Config Summery and changed configuration and re-booted, as recommended, which got me nowhere. Next, I looked for a valid image in flash using the "dir flash:" cmd which came back with the followed results: File Size: 896 bytes (0x380), Checksum: 0x306e, File Name: Start-up Am I correct in assuming that this means there is no flash file? Next, I started an xmodem procedure, this was going well right up untill the time when I needed to download the appropriate file from Cisco. I was able to navigate to the download page for flash file: WIC-xAM-V2-F49-1922F-4M-image.bin. However, when I tried to download the file I was halted with the details that I "don't have a valid service contract associated with my cisco.com profile." So, I'm stuck, in ROMmon mode to be procise. Does anyone have any suggestions of what I should do next? Many thanks, Olly. ... View more