Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to open up port 32400 on my 881w Cisco router but I have not had any success I need to configure manual port-forward to enable my Plex Media server. Can someone help me out wiht this set of cmds?Thanks!
I search and read several forums that I have to Bridge the AP to VLAN1 which has the DHCP pool. For some reason when I try to do this from iOS console it tells me that gig0 is not a bridgable interface. I am newb to Cisco iOS (24 hours new ). I got ...
Interesting... I had it pluged into my old wireless router so that internet was still available and it should have provided an IP, it does for any other device plugged into the port. I pluged it direct into my modem and got and IP (I had done this fi...
Ok I managed to get it set to Bridge 1 and I got an IP perfect... ..Almost Now the WAN port Fe4 will not bindI get CiscoRouter#renew dhcp fastEthernet 4Not in Bound state.Here is the interface details:FastEthernet4 is up, line protocol is up Hardwar...
Ok the AP side keeps reloading the default configuration. I was able to fix the switch to not do that by following the directions here:http://www.cisco.com/image/gif/paws/6201/lose_config_6201.pdfThe config register on the AP side is: Configuration r...
Ok I found the wireless config from launching the http: configuration server on the AP. Maybe config should be Bridge Gropup 1?!
! Last configuration change at 18:40:22 UTC Thu Apr 20 1905 by Cisco
! NVRAM config last updated at 18:40:22 UTC Thu Apr ...
