Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Why does the cpu utilization differ from adding up all the processes for that time frame. Example below, for 5 minutes it says 52% but if you all up all the processes, it's less then 10%. Where is the other utilization coming from??? PU utilization f...
Ok, I have never been able to figure this out. I have a Cisco 2511 terminal server. Is there a way when using SecureCRT to bring up multiply devices going through the terminal server. What i keep doing is ctrl-shft-6-x but that's only going to be dis...
On my 2811 routers I don't get anything in the sh log. I've shutdown and reenabled interfaces and nothing appears in the log.gateway(config-if)#do sh logSyslog logging: enabled (0 messages dropped, 3 messages rate-limited, 0 flushes, 0...
Without using a routing protocol I wanted to use my laptop with is going into a fa port int my first switch and telnet to the neighbors of that switch. My pc ip is 1.1.1.2 the switches are configured for vlan 1 with switch 1 ip 1.1.1.1, sw 2 ip 2.2.2...
When I console into the my 3550 and 3560 switches i'm not able to see the messesage appear if a interface goes down. But If I use a putty session and telnet into my directly connected (i can't see the logs only on a sh log) or telnet into the other ...
I'm still not getting any logs.Router# sh logSyslog logging: enabled (0 messages dropped, 4 messages rate-limited, 0 flushes, 0 overruns, xml disabled, filtering disabled)No Active Message Discriminator.No Inactive Message Discriminato...
Ok, i did and then shut the inface and bought it back up. I was able to get a log but doing that on all interfaces will it allow me to have debugging logs and etc sent to the console?Syslog logging: enabled (0 messages dropped, 4 messages rate-limite...
