Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey all --
This is probably a very basic thing and I'm just not doing it properly. I'm trying to connect two 1921 routers together using the following setup:
Router #1
gi0/1 10.10.1.1 255.255.255.0
Router #2
gi0/1 10.10.7.1 255.255.255.0
There ...
Hey all--
I'm currently setting up a new ASA. I've got the site to site vpn working, but i'm not able to ping across. Packet tracer tells me it fails on an ACL level
Here is the full configuration:
Result of the command: "show run"
: Saved:ASA Ver...
Hello,
I'm going to configure an upcoming 2901 router, it has "flash0:c2900-universalk9-mz.SPA.150-1.M5.bin" currently loaded on it.
My question is, does this have full BGP capabilities? I didn't see any ip-services listed under the software sectio...
Looking for some assistance in my BGP configuration. I have a peer (172.26.10.10) not coming up. I have a small porition of the config, let me know if you need more. I've also posted the logs of what i'm getting when i bring up gi0/0/0.129. I have tw...
Sorry, I should have said its "EVC" technology, point to point was not the correct way to describe it.
I've discussed with AT&T, they say all they do on their end is provide layer 2 connectivity and ports are set to access mode. That's typically all...
Richard,
We are implementing an AT*T ASE Layer 2 point to point. We will have 4 total sites all connected through this system. We were trying to make each gi0/1 "WAN" interface its own subnet, for purposes of its easier to tell which site is which.
...
I'll have to get more information from AT&T about their router setup. As far as I know, I'm going router to router. I'll get back ASAP with this information.
This is the reply I got recently from AT&T:
Changing the ASN is just a logical MACD but the ...
