Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I don't see where the current rommon is listed, but I did point out that for the USB method 12.4(13r) or later is required.http://www.cisco.com/en/US/prod/collateral/modules/ps6247/prod_qas0900aecd80232483.htmlIf an older rommon is on the router I wo...
Hello,The memory in this line of the sh ver is the physical DRAM installed.Cisco 2821 (revision 53.51) with 223232K/38912K bytes of memory.So in this case 256MBOn boot up, part of the memory is carved out and assigned to the I/O pool. Then IOS decomp...
Hi leolaohoo,Yes, I should have been clearer. When I say supported I mean from a TAC perspective.http://www.cisco.com/en/US/prod/prod_warranty09186a00800b5594.htmlYes, some other flash cards will work and smaller ones seem to have better success.The ...
The only supported USB sticks are Cisco branded. I've seen smaller non-Cisco sticks work as well. Install the USB stick, then from rommon issue the 'dev' command. That will print out the file systems that the router can see. If it recognizes your US...
