Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a dsl connection at a remote site that uses ppp over ethernet. Found out the hard way that it is not supported on the pix 501. So I bought a dsl router that supports pppoe and it works great. I can use the vpn client to tunnel into the vpn...
Got a good one for you guys. This is a routing issue to network without routers.I have a remote site that connects through a pix 501 to a cisco 3015 concentrator. (public interface of concentrator is on the dmz of a sonicwall pro vx) This works fine....
I opened a tac and got a good sample config from one of the techs. This worked great and I did use the information from both of those documents as well to get this working. The config for the pix 501 is much simpler than that of the bigger pix's u...
thanks for the tip on redistribute.i have rip v2 running on both the router and the lan interface of the concentrator and when i do a "show ip prot" i can see that these 2 devices are "ripping" with each other.what about doing this:router ripversion ...
Another easy way to resolve this issue is to use a hosts file and put the entry for that server in there. hosts files are not a very flexable solution but it does work. now when you "ping servername" it should go. Still need wins though to access ...
I am not entirely sure either. Same thing gets installed for vpn 3000 client. I do know that when I set sygate personal firewall to block it or uncheck it from network neighborhood, you cannot connect to vpn concentrator.
