HiI want to apply security to a switch allowing to connect several machines in different ports of the same switch.To do this, I issued the command# switchport port-security# switchport port-security maximum 3# switchport port-security mac-address sti...
hiI have a Catalyst 4506e that works fine but if reload, it boots in rommon mode. I can start it with a boot command, but by default, i must type a command. My config-register is 0x2102.Thanks
HelloI have 2 web servers that replicate between them (two different internal ip). My idea is that if one of them will not work, the other to do the relay.I have a Cisco ASA 5505 I can do a nat for each machine. How should I set
I appreciate your effort.At the moment, wireless networks are not allowed for this type of equipment for the health care system here. I'll find another solution or I'll get used to see the ports without security and accessible to anyone.thank you ver...
I will explain my problem to see if you have another idea.I have 14 machines to connect in a building (not computers but food carts) that travel through the different floors of a hospital. About 3 of them must be plugged to some ports on the same flo...
Thanks for the replyAnyway, I figured that would not be possible but I do not find useful. If for a training room, we deliver 20 laptops and we want that only those computers (and not bringed by users) will be connected, the "switchport port-security...
Hi ArumugamFirst, thanks a lot for your help.I understand that if my image is corrupted or deleted, it will be impossible to start with a "boot" command from the rommon mode. I have no device available on slot0 and my config-register is 0x2102, so my...