About Robert Salazar

Robert Salazar · 12-01-2010

IntroductionResolutionReferences IntroductionThis document describes a scenario where user receives a message when Anyconnect fails to connect.The following message is displayed during a failed anyconnect attempt: "The server certificate received or ...

Per user bandwidth rate limit. · 02-20-2014

There are Advanced Attribute Settings in the Authorization profiles.There is a bug in WLC code that effectively ignores the AV pairs sent from ISE.Bug id is CSCsd14297. Should be fixed in 8.0 code.Will have to wait for that version for now.

Robert Salazar · 02-17-2014

With "IP device tracking" configured, add the following command to the switch: ip device tracking probe use-svibounce the port and issue a 'show ip device track interface gi2/0/46'

Robert Salazar · 01-30-2014

How many policy nodes is your switch or controller pointing to?If it's more than one, can you change your switch to temporarily point to one (remove the second node) and see if the issue persists?

Robert Salazar · 01-21-2014

What error message do you see?Normally if the license has expired or needs to be replaced, the server needs to be reset to factory default in order to install the license.http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_system/5.4...

Robert Salazar · 01-18-2014

If this is a windows xp SP 3, see if the following hotfix is installed:http://support.microsoft.com/kb/960655If not installed then install it and restart the xp machine. See if the issue is still present.

Member Since	‎04-10-2002 04:45 PM
Date Last Visited	‎02-16-2021 03:48 AM
Posts	81
Total Helpful Votes Received	71

User Statistics

User Activity

Anyconnect 'The server certificate received or its chain does not comply with FIPS'

Per user bandwidth rate limit.

Re: MAB Authentication with no response

ISE v1.2 - Endpoint abandoned EAP session and started new

Cisco ACS 5.4 License

Cisco ISE authentication failed for Win XP SP3