Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Having an issue doing a port translation on an ASA5505 for RDP.I have a /29 allocated by ISP and when I port forward the address assigned to the outside interface RDP works perfectly, however when I try to use another IP within the /29 range, I ge...
Hi Jouni,Still the same... I am going to give up on this for the time being as I cant be bothered trying to explain this to customer service at the ISP... will end up wasting more time. I have forwarded all RDP to the interface IP and all works there...
Hey Jouni,Packet capture gave me this output which didnt have any TCP 3389... but had some random UDP ports only? 1: 21:54:55.108377 802.1Q vlan#2 P0 X.X.X.218.63420 > 208.67.222.222.53: udp 44 2: 21:54:58.751929 802.1Q vlan#2 P0 X.X.X.218.6342...
Hi Jouni,Traceroute follows the same path up until the interface IP address and does not go any further, although I am not allowing ping/traceroute to the other IP addresses, only the outside interface IP...Seems like it is routed to the right place ...
Jouni,OK..., packet tracer output shows allow on all points which is confusingResult:input-interface: outsideinput-status: upinput-line-status: upoutput-interface: insideoutput-status: upoutput-line-status: upAction: allowAfter the packet tracer ther...
Thanks Jouni for the quick response...Wish that were the answer... a sh run sysopt gives nothing... I added the no sysopt command and still no joy.I had thought about calling the ISP however this ASA is a replacement of an PIX which I only just put i...
