Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone else experienced this problem? I had an ECC error yesterday on my B200-M3 blade. The blade recovered properly, but the ESXi (5.1u1) software hung hard.Is anyone aware of any bugs that might cause this problem?Thanks, -Steve
Hello, After upgrading to the 2.1(1a) firmware, I noticed that two of my 8 blades want to boot into this new Configuration Utility after the service profile has been applied. The software just sits at Initializing Kernel forever.Does anyone know ...
Thanks, I was actually curious if there was some sort of heartbeat that was able to identify that VMware was not running and reboot the blade. Something in the back of my mind says there should be something we can set to make this happen.I was lookin...
Hi Mike, After working with TAC, it was determined because I cleared the ECC (and he could not find the error in the event log) there was nothing else he could do. Because the machine was back up and running I left it to be addressed by VMware to...
Thanks Mike, I already opened a ticket: 627424227, but TAC said there is really nothing they can do about it.I am waiting for an answer back from VMware. -Steve
Hi Dave, Here is what I have figured out after my investigation. All of the systems that are booting into this utility have a 16gig Cisco stick in them: 17-11213-01 and they have two linux partitions on them. (I assume one is the boot partion). T...
