Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,My question is it possible to convert the any two ports of asa5520 as L2 ports . If so kindly let me know how that should be done. We are planning to connect our hsrp switches to these switch ports instead of using a separate switch thats why...
The Issue we have two 3750 switches and configured hsrp on that . Now instead of connecting these two swiches to an Intermediate common switch we have a cisco asa5520 which has 3 L3 ports of which is it possble to convert 2 ports as L2 ports and use...
We have two asa5520 in active/standby failover setup . It happened so that primary got failed and the traffice is routed through secondary . When we saw the "show failover" the reason stated for failover says that " service card failure" and when we ...
We have two asa5520 in active/standby failover setup . It happened so that primary got failed and the traffice is routed through secondary . When we saw the "show failover" the reason stated for failover says that " service card failure" and when we ...
Hi,My issue is i have created two vlans in 4948 core switch one for servers and other for systems(users) . We have created access ports for server vlan in core switch itself and connected the servers in those ports and trunks have configured between ...
Hi,Thnksthe purpose is we have to do hsrp config on the 3750 switch and connect it to an intermediate switch and connect the asa to that switch so that ASA is also part of the network when one switch fails and standby takes over . But I dont think th...
here does that 10.1.1.1 refer to the multicast ip address(example) ?because the server vlan is in 172.16.0.254 and users/system vlan is in 172.16.100.254 both /24 .
