Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. I have a stack of three 9200L switches in which one of the links is OK but not Active:9200L#sh switch stack-ports summarySw#/Port# Port Status Neighbor Cable Length Link OK Link Active Sync OK #Changes to LinkOK In Loopback---------------...
Hello. Do Catalyst switches log all supported messages by default (with regard to the logging level and discriminators), or is there a way to turn some messages on? To be specific, some of our Catalyst switches log these messages when a user logs out...
Hello. Is it possible to create an ACL on Firepower which gets IP adresses to block from a network feed?
We have a custom network feed, auto-populated on a given number of failed RA VPN login attempts in a time interval. The feed is on a RADIUS serve...
Hi. Config guide says ASA should pass PIM-SSM through when it's not LHR. Are there any commands to enable that? I see packets from source to 232.x.y.z in capture on the incoming interface (outside), but not on the outgoing (inside). ASA version is 9....
Dear Marvin, with all respect, confirming both You and @balaji.bandi didn't see the following sentence in my initial post:
> I'm NOT talking about "set connection decrement-ttl" .
I need to increase TTL, not decrement it... Any ideas? Thanks and bes...
Hi. I know the document, but as far as I see, it doesn't say anything about the feature I need. Any other ideas?
Meanwhile I've found this topic which mentions Multicast Service Reflection (MSR) on IOS routers: https://community.cisco.com/t5/routing/...
So folks, thank you both for help. The first policy went fine. Here's the outcome:
- Before I assigned the first flexconfig policy to our FTD HA pair, Preview Config button was grayed out.
- But after I assigned the policy and before I saved the chan...
So, it would be sufficient to compare "show run all" before and after new FlexConfig policy, assuming there are no other changes in the same deployment?
