Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. I have a stack of three 9200L switches in which one of the links is OK but not Active:9200L#sh switch stack-ports summarySw#/Port# Port Status Neighbor Cable Length Link OK Link Active Sync OK #Changes to LinkOK In Loopback---------------...
Hello. Do Catalyst switches log all supported messages by default (with regard to the logging level and discriminators), or is there a way to turn some messages on? To be specific, some of our Catalyst switches log these messages when a user logs out...
Hello. Is it possible to create an ACL on Firepower which gets IP adresses to block from a network feed?
We have a custom network feed, auto-populated on a given number of failed RA VPN login attempts in a time interval. The feed is on a RADIUS serve...
Hi. Config guide says ASA should pass PIM-SSM through when it's not LHR. Are there any commands to enable that? I see packets from source to 232.x.y.z in capture on the incoming interface (outside), but not on the outgoing (inside). ASA version is 9....
Today I made a series of experiments, connecting just two of the switches. Stack of 1 and 2 - both links active. 1 and 3 - both links active. But 2 and 3 - NONE of the links active! This time I performed all the experiments with the same modules and ...
Dear Marvin, with all respect, confirming both You and @balaji.bandi didn't see the following sentence in my initial post:
> I'm NOT talking about "set connection decrement-ttl" .
I need to increase TTL, not decrement it... Any ideas? Thanks and bes...
Hi. I know the document, but as far as I see, it doesn't say anything about the feature I need. Any other ideas?
Meanwhile I've found this topic which mentions Multicast Service Reflection (MSR) on IOS routers: https://community.cisco.com/t5/routing/...
