We can trace from cli on asa5510 (8.0(3)) but can not from inside host. We have icmp and echo-reply on both interfaces. The logs show successful building/teardown of ICMP to/from the faddr and there are not any denies by acl's or errors.Any clues by ...
We are seeing rate limit drops on a new internet ethernet connection. I can't seem to find an explanation that does not have Qos in the reason for the rate limit drops. Here is what we see on a ASA 5520 running 8.3.Interface GigabitEthernet1/2 "out...
Problem:Outside access to Inside Citrix server.IP Info:ISP gave me x.x.x.16/30 so my IP address on e0/0 is x.x.x.18ISP gave me x.x.x.24/29 as usable IP address's IP's I want to use:192.168.76.12 = Citrixx.x.x.29 = NAT to CitrixOn last site I had a /2...
I have two 5510's that I am trying to get a tunnel established. One has an exsistinig tunnel to a 5505 that works but I cant get the next one to get past the first phase. I have sanitized the attached configs, can anyone see something obvious?
We have a hub and spoke VPN setup and at one location used the DMZ port/vlan subnet to access the hub. We have since changed and want the DMZ to only access the outside interface (have base license that can only access one interface). We have taken o...
Michael,You hit it.While they do climb (at very little increase) during no load times,, when I flood it the counters start cranking up.There is/was a simple explanation that makes perfect sense. THANKS!!C.T.
It is a 100Mb Ethernet link and get anywhere from 85-94Mb down and 83-89 up, which is OK.I just got the ISP to give me stats out of their interface.HSNN48H1C7001#sh int Fa0/1 FastEthernet0/1 is up, line protocol is up (connected) Hardware is Fast E...
Shawn,Upgrading from 8.3 to 9.1 is not an option without extensive testing. (also, not really sure if this has any impact on the actual link, we get 90 up and down pretty consistently) This was more of an educational/knowledge question than a 'I have...