Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,IR 809 fails to boot properly if the USB storage is inserted during power up. Boot stucks in rommon-1> and there's no way to make it run. I tried to bootHV from the usb drive but this failed as well. If I try to dir there are some errormessag...
Hi guys,I'm looking for some tips regarding how to properly use RS-485 serial port on IR 809to connect to the MODBUS RTU sensor.I followed the guides I've found, but the configs focused on RS-232. I've changed the media-typeto rs485 for the async 0 i...
Hello,All in a sudden the Spam & Virus Blocker's web interface become unusable.It is possible to log in using the admin account, but any further action usually ends with the Application Error page being displayed.I attach the corresponding screenshot...
Hi,Does anybody know the password recovery procedure for admin user?The password has been lost and currently spam blocker is unusable.--Best RegardsGabriel Kujawski
No I cannot. As I wrote flash: and bootstrap: are not available (empty)if the box is boot up with usb pen drive plugged in. If pen drive is FAT32, then dirlists its content. In this state I've tried to boot up the HV directly from the usb:then over t...
I've just format the usb storage with ext2. rommon-1 fails to mount itbut at least shows that it was recognized by system as /dev/sda1... I assume thatrommon-1 expects internal flash at /dev/sda1 and plugged in usb storagesomehow overrides the defaul...
Hi Steve,The issue is not with the python script. The script works correctly and queries the modbus device in 5 sec interval.The only caveat is that it works for some time and then fails to read the device. According to mine troubleshootingsession sc...
Hi,After a couple of weeks I tried again with newest IR 809 software on board.Here's my python scripthttp://pastebin.com/0RvNXBDLHere's my config:http://pastebin.com/v9J9QmeJAnd the script works only for 30-60 seconds. Then transmission stalls.If I s...
