Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I've got a little problem with my ASA 5515-X after upgrade from version 8.6 to 9.1.I've got two 5515-X in A/S-mode and upgraded both as described on cisco's website (first standby-unit, failover, etc.). Everything worked just fine except pin...
Hi there,I hope I'm right within this board.If not: please move and excuse me My question is about requesting information via SNMP from my two stacked C3750X, running IOS 12.2(55)RE5. The stack is up and running and everything is just fine. There are...
OK, that's new to me and I should remember this - it'll maybe an issue in future again So now it workes like expected and I get this output for "show capture ICMP":6 packets captured 1: 06:58:01.147026 802.1Q vlan#v P0 192.168.x.h > 192.168.y...
Hi and thanks for this advice.I'm quiet new to troubleshoot issues on ASAs like this, but I can imagine, what the above config should result. Unfortunately the ASA tells me this when I try to configure the capture:Capture doesn't support access-list ...
Great... A bug...But thanks for the reply, it helps me not to lose my mind So SNMP answers only for the stack-master with two fans, thats annoying So I have to report it to cisco I guess...
Unfortunately not, I got these information, too, but there are only three fans in the result-set (in my case), but there should be four. In your case there are 6 fans, but it seems that there are 5 switches!? Thats why I guessed if there will be only...