Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I believe you are looking to configure Cisco Callhome. You may use Cisco Fabric Manager to configure callhome, and here is a
doc that talks about it step-by-step -
http://www.cisco.com/en/US/docs/switches/datacenter/mds9000/sw/5_0/configuratio...
Hello,Release notes. Refer to Table 4 - http://www.cisco.com/en/US/docs/switches/datacenter/mds9000/sw/5_0/release/notes/fm/fm_rel_notes_507.html#wp727733Windows Server 2008 64 bitDownload link (once you are logged into Cisco.com with your cco userid...
Hello,Is the device logging into fabric A ? You can use the following commands to verify - show flogi databaseshow fcns databaseshow npv flogi (if this is an NPV enabled 9100)Is the zoning set up correctly for this device (show zoneset active) ? Is i...
Hello,Are you trunking the native vlan as well ?Can you provide the part of the config where you are associating the vlan to the vsan ?Also, please provide -show vlan fcoeshow run | in "system qos" next 5Thanks,Arun
Hello,If this is for DCNM LAN, you can use the pwreset.bat (off of Cisco\Systems\dcm\dcnm\bin) file to switch the authentication to LOCAL.If you are doing this for a DCNM SAN user, an admin user can change the mode to local in server.properties f...
