Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a PIX firewall that needs an additional IP range assigned to the external interface. Is it possible to assign a second non-contiguous IP range to an interface? If so, how is this done? I don't think I can use the "secondary" command that is...
Hello. In the near future I will be implementing failover capabilities to my current PIX and switch architecture. I understand how to configure the PIX for Active/Standby failover, but I am concerned about switch redundancy. I am planning on setti...
If set up a trunk link between an external router and a managed switch to allow all traffic from VLANs on the managed switch to travel across the trunk link, will this automatically enable inter-VLAN routing? Is there a way to enable all traffic to ...
Thank you for the information. I wanted to run this config. by someone to make sure I didn't miss anything. I do have one more question about a PIX in active-standby mode. On the standby PIX, what is the status of the fe port connected to the swit...
Erick,Thanks a lot for clearing up my confusion. One more question: in the design you mentioned earlier, is the 2621 only there to route VLAN information?Thanks
Here is what I am trying to accomplish. I need to create 3 subnets which cannot communicate to one another yet pass all traffic through the same firewall to and from the Internet. I was wondering if I could setup 3 VLANs on a Catalyst switch, then ...
Thanks for the information. It looks like I will not be using a router. If I do not use a router then the VLANs will not be able to communicate with each other; however, will the machines on a VLAN be able to receive any traffic from outside of the...
