I've never tried it on a WAP, howerver here is the config that works for Windows clients on a Cisco Router.ip dhcp pool network domain-name dns-server netbios-name-server netbios-node-type b-node default-router I use this config to...
Just set the port your WAP is connected to as if it were a workstation with your native VLAN. Then trunk it and your port will be trunked with the proper native VLAN. CatDC1> (enable) set vlan *Now the native vlan is assigned to the port*Now trunk ...
I have both Air Magnet and Airopeek NX. Airopeek is an excellent tool and quite a bit more easier to navigate as it runs on your laptop. I like to use Airopeek NX to troubleshoot actual problems and Air Magnet when scanning for rogue APs. I have fou...
Hi,I have experienced the same problem when running 12.01T1 on the 1200 series access points. You can disable the switch to repeater mode function by selecting the following on the AP configuration page:Setup --> Ethernet --> Set Properties You shoul...