Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just thought I'd share my experienceI just finished setting up a VNX5300 via FCoE, directly connected to two 6248UP. All the zoning was completed on the FIs with no upstream 5K or MDS Switches and all worked well.
Hello Everyone,I am also curious......can someone confirm if you can zone directly from the FIs if you are connected FCoE from VNX direct to FIs without MDS or 5K. Current SetupVNX5300 with 10GB FCoE IO Modules in each SP2 x FI 6248UPRunning UCS ...
LukeAs long as the you have the native vlan setup appropriately then yes you would leave the management vlan blank on the ESXi side. When creating additional port groups in vmware (vmotion, iscsi, vm traffic etc.) you would specify the appropriate ...
Luke,Just to confirm you said you have logged into the KVM on the ESXi host and verified you are tagging VLAN 10 on the managment network (vmnic0)? If this is true and you have the native vlan set to vlan 10 on the vnic in the service profile of UC...
