Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've configured the Guest Web Authentication in the ISE and I've tested and every thing is working fine. I got the redirect url, I could authentication and then got an access. However, If I got the redirect url and then disconnect from the guest SSID...
I have an issue in ACL-POSTURE-REDIRECT to download the NAC agent. I got the right page to download and install the agent from the access switch. However, I got error status-2 when trying to download the agent. The intial ACL was as followsip access...
it is written :" In ISE, client will be restricted by pushing ACL , vlan can also be pushed to the client but change of vlan not yet supported for wireless client after posture validation as per wlc 7.0.116.0"Is that possible in wlc 7.2 ?
Thanks Marcin.Acually we have an issue in step 5 where I could not be redirected. When have you disconnected from CWA, did the RADIUS session in the ISE removed ?
I can terminate the session manually by going to :Operations > Reports > Catalog > Session Directory >RADIUS_Active_SessionsWhen I did that, the samrtphone is disconnected from the SSID and then connect it again, and I get the redirect URL with no is...
Thanks Marcin for your reply.I have ISE 1.1.3 with WLC 7.2. The accounting on the WLC is configured. I need to check the "show client det " command.But I can see it in the GUI of WLC after I associate with guest SSID but without the redirect url wor...
