Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am using ACS 3.3 and would like to assign a privilege to someone who have full right for switch and read-only for router. However, ACS only allow assigned single group in user setup. How can I configure for meet this requirement?Thank You.Ray
Hi,I saw a "Shell Command Authorization" section, but there only have 3 options which are:1. None2. Assign a Shell Command Authorization Set for any network device3. Per Group Command AuthorizationThere have not "Assign a Shell Command Authorization ...
Hi Ahmed,Some staffs need a full right for all network devices, but I cannot add a same device into the other NDG. It said that IP is conflict with other NDG.BRRay
JG,I have not found "Assign a Shell Command Authorization Set on a per Network Device Group Basis" option in group setup. Do I need to enable something for activate it?Thank you.Ray
