Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 521 WAP on my network. It got a DHCP address and I can PING the 521.I created a community and told it to Discover using "a single device by IP address". It fails to connect. I am trying to roll out six of these in standalone mode. Any he...
I just got six 521 AP's. If I plug the laptop to the Console port, I see errors reading the flash image. I have tried this on two of the six. The CCA software does not see these units either. Any ideas? Where can one get technical level info. on...
Very helpfull information! Thank you. It did not occur to me that I should look in the Aironet 1200 Series documentation to figure out problems with the 521/526 equipment! Is there any detailed information specific to the 500 series? The document ...
Can the 526 controller handle six LAP521G-A-K9 access points if the access points are on different subnets? If this is the case, that would solve my problem. Thank you very much for your help.
At this point, I don't know if I ordered the wrong model number or the vendor shipped them in error. I need these on line quickly! How can I change the firmware to make a "lightweight" into a standalone model? I know that only three standalones ca...
I have not seen the terms "autonomous" or "lightweight" in the literature! All I know is that I ordered "standalone" models. they are marked "AIR-LAP521G-A-K9" does that help?
What is the "community string"? I was trying to use the "connect to a single device" option rather than create a community. Are you using these 521's on a Cisco Catalyst switch? I am using a 3com or Dell switch.
