Hi Stephen, We've used the SRP a couple of times with good effect, PPPOA works a treat, you just have to change the set up (quick set up/WAN set up/change the encapsulation drop down and the rest of the authentication page appears after selecting pppoa. It's a nice little router Hope this helps. Phil.
... View more
Hi all, Has anyone attempted connection of the UC320 to a door access system? is it possible and what are the connections and/or instructions? I have only FXO ports available as the fxs will be used elsewhere. I won't know what the 3rd party door system is until I get to site this week but i'm assuming that I just need to open or close a connection and the 3rd party kit will activate a switch relay or something. Thanks in advance for your help. Phil
... View more
Hi Chris, Problem solved, it was the outside ip address of the UC320W that should have gone into the uplink box on the network interfaces tab on the Mediatrix Gateway. for all of my looking i just failed to see i'd put the inside address. I guess it will get easier the more of these i do!. Thanks for being there. Phil
... View more
Hi, I'm having a problem with incoming calls not routing. Outgoing calls test ok but i'd like to fix this before getting it to site! I have followed the "deploying mediatrix 4400 digital gateways with UC320W" document, although i have a Lynksys X2000 as the router its exactly the same topology.. Calling the DDI from my mobile you can see activity on the 4402 but just get silence on the mobile end, On clearing down, the activity goes away as you would expect. I have tried a couple of scenarios where i have aimed all BRI calls at one extension, then tried adding the DDI and routing to both a single extension and a hunt group to no avail. I have turned off all firewall on the X2000 (temporarily) and still nothing. I know it's going to be a tick in a box somewhere but i just can't find it. All firmwares upgraded etc and if i have to watch another reboot i think i'll go nuts! (looking forward to that fix i can tell you!) Many Thanks Phil
... View more