Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco 2901 with the 4port gigabit ethernet switch module that I'm trying to get configured to have a seperate subnet for each port. So far I have it set up so each subnet is a vlan, then on each port I use the switchport access vlan command...
Thanks for the reply.The other device is a Cisco ASA.I was afraid I could only have a switchport belong to only 1 vlan, and I didn't think the trunking would help me, but I gave it a shot anyway.Any suggestions on how to configure that one switchport...
