Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I've got a 1242AG LAP that's registered to a 4400 Controller. Problem is, it won't boot properly. When I plug into the console port, I see the following:The system is not configured to boot automatically. Thefollowing command will finish loadi...
I have the same problem with a 1242AG, which is managed by a 4400 controller. It boots fine after I type "boot" into the console. Not sure how to set "Conf reg" to the indicated value, either through the console or the 4400.What I can't seem to fin...
