Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have deployed a pair of 1310 in bridge mode and data are passing through OK. the two bridges are connected to trunk ports of cisco switched on both sides. In order to pass voice through the bridge, do I need to configure voice Vlan's in the 1310 as...
The problem remains. I cannot make 3 different Vlans (10, 20, 30) pass through the wireless bridge.the wireless bridge is set uo with SSID bridge, and it is the only SSID that exists.
OK, but I have one question. after performing the above, the AP will work in Autonomous mode? I would like to keep the LightWeight mode on the AP in order to use it with the 4402 Controler.Thank you very much
We tried to connect via console to LWAP directly, but it does not let us write a configuration. the AP does not accept any configuration. can I connect to the AP's console via the controller and set the IP from there?Thank you
