Can anyone tell me a good way to load balance outbound connections between 2 different sites that are connected with high speed fiber metro links? I have 2 sites with the same ISP providing outbound access at both sites. Each site has users and ser...

I am replacing some 4908G L3 switches with some 3750G L3 switches and am having a problem with the bridge protocol command. On the 4908s I have the following commands… bridge 1 protocol ieee bridge 1 route ip bridge 1 priority 100However on ...

If I have Spanning Tree enabled and redundant links between switches will sho cdp nei det show all the connected links (even those that are not passing traffic because spanning tree has disabled them)?