Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have come across some issues loading a config onto an ASA5515 device. The device is used to allow 4G Android device access to a small network.
From factory default the ASA is given a base config which basically just ip's an interface, from t...
Hello,
What is the Management Interface on an ASA 5510 / 5520 meant to be used for...?
I am not a firewall boffin by any means but recently I've had to set up both 5510 and 5520 ASA's, part of the set up was to use the management interface for the sy...
Hello,I have 2 Cisco SX20 with ISDN Link systems that I want to connect over a LAN.I have paired both units and given them ip addresses in the same subnet, my first question is what the defaut gateways of each unit should be pointing to...My second q...
Hi,
So I've had a chance to look at this again, here are a couple of things i noticed that might help someone point me in the right direction.
in the Base config that is loaded first are these 2 lines:
crypto key zeroize rsa noconfirmcrypto key gen...
Hi Flavio,
Thanks for that, I'll have a look tomorrow on the real kit.
The only thing that doesn't work when i tftp the config to startup and reload is the 4G device access, so I know the config is being loaded but i'll check for sure tomorrow.
Thank...
Hi Flavio,
I'm very limited to what I can post from the actual device, this show version was taken from GNS3 using the same image and config, I've taken a couple lines out but other than that it's the same as the real one.
ASA11(config)# show version...
Hi Marvin,
Thanks for your reply,
That sounds like the way I have it is fine then, I've noticed that some people here have the snmp set up for the Inside interface but i think i'll leave mine as it is.... seems to working fine.
Thanks again.
Thanks again Wayne,I got the screen back using the remote key sequence " Disconnect, *#*#01#" which i found in some knowledge base document.one of the units has come up with an error saying it's missing a Release Key so i can't access the Administrat...