Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have failover active/standby topology with two ASA (version 8.0.4), and Clientless SSL VPN configured.I have created differents profiles, bookmarks and portal in this solution. But when I try to see this files in the standby unit, I can't to see...
Hi, We want to buy a certificate SSL to change the actual certificate in ASA. Are there any requirement or specific type of certicate compatible with ASA?Thanks
Hi,I have very questions about X2 and XENPAK transceivers:1) Can i connect a X2 trans with Xenpak trans?2) Can I connect a X2-CX4 with Xenpak X2-LX4?Thanks
Hi Franco,put this command in your switch: show vtp status example:show vtp statusVTP Version : 2Configuration Revision : 0Maximum VLANs supported locally : 254Number of existing VLANs : 5VTP Operating Mode ...
Hi,I think that the problem is that you want to create a vlan with a number higher than 1200. Can you try to create this vlan with a lowest number?Bye!
Hi,inside the configuration in the interface, put this command:encapsulation dot1q vlan XXXXXX = vlan numberAfter this, you can put the ip address in the interface.Merry Christmas!
