Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have to manage a wlc 4404. According to me he acts strange.Only ports 1,2 and 3 are connected. The ap-manager and the management are linked at port 1. So far so good.If I look at the wireless-tab I see all AP's are connected at port 3 !! All ...
Problem is solved !I added a new ap-manager interface active on port 3. I disconnected port 3, 48 AP's switched to port 1. After I reconnected port 3 all other AP's connected to port 3.
Physical interface is port 1.After the hours I am going to disconnect port 3. I hope that all AP's will switch to port 1. If not I hope the logging will give me some light in the darkness.Thanks for your input.
I am not using LAG. I have setup an AP-manager on port 1 not on port 3. But all AP's are connected on port 3. At the moment I have 48 AP's. I add 15 new AP's on the same switch, three of them can connect to port 1 (ap-manager), for all the other I se...
