Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If the switch in this scenario supports WCCP, I would use it instead of the ASA. If you must use the ASA, then make sure you are running 7.2(3) or newer code on the ASA. The configuration you listed looks fine, except the redirect-list ACL might be...
Abhi,If you grep the accesslogs for the IP address of the Windows 7 client, do you see it trying to connect to a particular site? In case you are not familiar with grep, connect to the IronPort CLI via SSH, and type "grep" and hit enter. Select the...
That router configuration looks good to me, but just make sure that the WSA was configured for Transparent mode during the initial System Setup Wizard configuration. If it was initially configured for explicit only, then you will need to run the wiz...
Just to make that a little more visual:Client <- SSL Conn 1 -> WSA <- SSL Conn 2 -> Web ServerSince the WSA is in the middle of these SSL connections, it can see the traffic unencrypted, but you still maintain SSL security across the Internet and L...
Which is funny, because the Windows 2000 boot screen says "Built on NT Technology". So basically, Microsoft's new technology at the time was said to be Built on New Technology Technology.Took some marketing guru to come up with that one.
