Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm not able to configure two ports on a C2950 as trunk ports, in order to connect to another similar switch. I did what's recommended: enconf tint range fa0/23 - 24switchport mode trunkendKeeping the default encapsulation (802.1q) The ports still sh...
yes, everyone in the network is in that rangeadded the switchport in Po4still can't login to sw4 once connected to sw1here's the latest sw4 config. btw: sh int trunk shows blank on sw4 while in stand-alone mode. Can't get in while connected to sw1 We...
yes, clients on sw4 work fine, vice versa.client on sw4: 192.168.1.239no matter which sw we come in from, once we telnet sw4 (192.168.1.244) we get the password prompt, as soon a key is entered , the connection drops. Even browser login fails I'm so...
Funny though, now that the new sw4 is behind sw1 via etherchannel trunk, and devices on it connect, I'm not able to telnet into it. As soon as I start typing the password it looses connection, also can't get in via browser. It only works if I remove...
Hi Jon,So my sw1 has a bunch of stuff on it: (I've attached the running config)fa0/19 - 20 already has an channel-group 1 (they go to another sw for phone) The existing connections (p21-p22 & p23-p24) on it to sw2 and to sw3 are however NOT setup as ...
