Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Folks, Based on Cisco documentation about NAT, the following ports are used during the overloading process. When configuring for PAT (overloading), what is the maximum number of translations that can be created per inside global IP address? A. P...
Hi members, I am currently troubleshooting a Gig interface that has increasing total output drops value.The Gig interface is connecting to a switch. We use subinterfaces on the router to connect to different circuits. I noticed that the total output...
Hi All, When setting community values under a route-map (set extcommunity xxxx) with the "additive" keyword, this prevents the new entry to overwrite the existing entries. However, is there such similar commands where you want to remove a particula...
Hi All, I have a question about SPT switchover and the role of the RP-bit set. As far as I understand, once the SPT switchover is completed, the last hop router will send a prune message back to the shared tree. On the upstream router where the las...
HI All, For PIM sparse-mode environment, does (*,G) entries on the show ip mroute table (last hop router) , means multicast traffic from the RP is flowing down and I can join the group? Do I need the (S,G) group to be present in order for the host ...
Hello Georg,That is what I did. It maybe overwhelming though looking at the QoS counters as well as its difficult to check if it is historical or not and sometimes depending on how your QoS is configured (nested, etc.) , you need to do some math to c...
HI Tim,Thanks for your comments.I am referring to communitly list under a route-map.Example as below:route-map abcd permit 10match ip address prefix-list xxxxset extcommunity 12345:1111 12345:2222 12345:3333 additiveI only want to remove 12345:3333.W...
Hello Giuseppe R8 is my last hop router....sending joins from the Loopback interface: R8#show ip mroute 234.2.2.2(*, 234.2.2.2), 00:14:55/stopped, RP 11.11.11.11, flags: SJCLIncoming interface: FastEthernet0/0, RPF nbr 78.78.78.7Outgoing interface li...
