Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have an ASA5506 with Firepower and i manage it with ASDM.Asa version is 9.8.1, Asdm version is 7.8.1.150, Firepower version is 6.2.0.2-151 I have connected the Management interface with the Ge1/8 interface directly. In the past, i succeed to ma...
Hi,
I'm configuring an Asa5506 and i have a problem with port forwarding.
My configuration is:
2 internet access > Peplink Balance 20 (load balancer) > Asa5506 > lan networksIn the peplink, i have setup a dmz for the Asa (working because i can use AS...
Hi,I have set up a site to site VPN between a WRV4400 and a SA520.The VPN is up but no traffic is passing inside. From each side, i can ping the remote gateway but i can't ping the remote network, i get "Request timed out".The SA520 is functionnal be...
Hi,I'm looking for a solution in order to connect some adsl connections. I know the Rv016 router which permits to connect up to 7 wan link but i need more, about 10-12 adsl connections. I need to increase my download bandwidth for my lan.I need the s...
Hi,I have a multiwan architecture with two adsl connections. I join you a scheme of the topology.Two modems TP-Link, provided by my ISP, in bridge mode, deal the dsl synchronization and a Cisco Rv0xx router deals the PPPOE authentications.I monitor t...
Thanks to you Aditya, i solve the problem.
I have to use:
object network obj_192.168.0.3
host 192.168.0.3
nat (inside_1,outside) static interface service tcp http http
Regards
I got an error with:
nat (inside,outside) static interface service tcp http http ^ERROR: % Invalid input detected at '^' marker.
In attachment a view of the interfaces.
This is the NAT Statement which DROP the packet.
obj_any1 is 0.0.0.0/0.0.0.0
object network obj_any1 nat (any,outside) dynamic interface
Show nat results
Auto NAT Policies (Section 2)1 (any) to (outside) source dynamic obj_any1 interface translat...
Hi Aditya,
This is the result of: packet-tracer input outside tcp 4.2.2.2 7676 my_remote_ip 80 det
Phase: 1Type: ACCESS-LISTSubtype: Result: ALLOWConfig:Implicit RuleAdditional Information: Forward Flow based lookup yields rule: in id=0x7f2cb8d1795...
Hi Luis,Sorry for the delay of response,I try to ping my network printer so this isn't a firewall problem.On the site B (wrvs4400n), the router can ping the printer. On the site A (sa520) so on the other side of the VPN, i can ping router B but i can...
