Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team, We have an issue in our UCS domain where we have some MAC table is getting above the limit and the reason we found is because a VM mac address that is creating multiple entries in the table with different vlans(all vlans tagged to host vnic)...
HI Team,I recently tried upgrading the C240 M4 (UCSM Integration) to 4.2(3g) C. Unfortunately, I have association failed with upgrading SAS Expander and not able to move forward with the upgrade. Any help would be greatly appreciated.I tried Reacknow...
Hi Team,I am building 2 nodes with Windows Operating System where OS has been installed on the blades and servers are reachable over the network. But we could not be able to get the HBA up to make visible in the SAN switches to proceed with Storage c...
Hello,I have setup running with 4.2(1n) with 2 * 6454 FI's and I am getting the frequent issue with UCSM GUI inaccessibility and restarting the pmon services to get the GUI back up online. Is there any permanent fix for this?This issue was there is a...
Hello,We are going to setup X series newly in one of our locations. Just wanted if there are any best practices to be followed and also need to know if this has to be set up in UCSM or IMM Mode as the datasheets for X series 9508 Chassis are having M...
Hi @Kirk J Thanks for the response and apology for the late reply... I was able to fix them by installing the drivers in the OS(which was not done part of the build)which enabled the FC connectiom and floggied to SAN switches..
Hi @Mark Elsen , Thanks for the response and apology for the late reply.... But I did noticed the bug and tried reacknowledged the server but no luck..
Hi Team,I still have this issue occuring , not sure if there is any configuration issue but config wise everything looks fine. Any help would be appreciated
