Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, in which scenario below statistic is found. Throttle count is 0 but RP drop count is very high?sh int fastEthernet 1/11 switchingFastEthernet1/11 Throttle count 0 Drops RP 1279481 SP ...
In my cisco 3845 router I can see output packet drop in some of the interfaces.I suspect that router is processing packet beyond its mix throughput limit. Moreover when i run show int fax/y switching command I can see packet drop by RP process. Can y...
Hi How to find out the duplicate entry with different subnet mask:%OSPF-4-CONFLICTING_LSAID: LSA origination prevented by existing LSA with same LSID but a different mask, Existing Type 171115136 LSA: LSID 255.255.255.240 0xA330280 New Destination: 2...
I have applied below police configuration into interface and below is the traffic statistic. I don't understand why 1011000 bps as shown as exceeded whereas normal traffic has not reached the set limit(100000000 bps). rate-limit input 100000000 312...
Hi NikOk.I am going to configure the SPAN on the affacted port and will take etheral capture in the time of problem occurs.I will take the TS when it heppens again. Please find the H/W & S/W version of router.sh versionCisco IOS Software, 3800 Softwa...
Hi NikI was troubleshooting an issue with Cisco 3845 router.The connectivity is as below,Router has five interfaces(Fe) connected with C2950 switch and they are assigned with different IP subnet. All ports of C2950 switch are in default VLAN 1 and f...
