Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am very interested in tuning my ASA Threat-Detection configuration. I desire for the device to shun addresses quicker for ACL failures and IP scanning. Any advice would be most appreciated.
I have been unable to schedule recurring reloads on my WAN routers. Any suggestions are very much appreciated: kron occurrence RELOAD at 00:01 Fri recurring policy-list RELOAD kron policy-list RELOAD cli reload after running, the router drops cli ...
Hello Julio,I have the following configuration and it does shun properly, i just want to tune it to shun faster.threat-detection rate dos-drop rate-interval 600 average-rate 100 burst-rate 400threat-detection rate dos-drop rate-interval 3600 average...
I had the basically the same type of question a while back, because i was receiving warning messages regarding licensing. It keeps telling me we are over our limit of 500 licenses, when i only have 250 users. The response i received from CISCO was ...
