Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Correct. You can to use the import/export capabilities to copy policies and device configurations over to the Nutanix FMC.The configure-model.sh is not supported by Cisco TAC and/or Cisco Engineering.Regarding the migration paths supported by the mod...
Once you typed a command and pressed Enter you cannot stop the output.
Furthermore, on FTD the default pager size is '0'. This means that the whole output will be shown before you can type anything else.
You can change the pager size for a sessio...
What you saw on Tuesday (6.2.3.9 listed under the affected versions) was a glitch that was fixed after few hours.What is shown now it is the correct info. 6.2.3.8 is affected by CSCvn82378, while 6.2.3.9 is not affected by CSCvn82378.
Well, I would say it depends:
If I was in 6.2.3.7 and hit a defect that was fixed in 6.2.3.8/6.2.3.9 then I would upgrade to 6.2.3.9If I was in 6.2.3.8 and was already affected by CSCvn82378 I would go to 6.2.3.9If I needed a feature from 6.3.x then ...
