The simplest upgrade procedure for the ASR1k is no different to any other router.1. Put the new image on the bootflash2. Change the boot line in the configuration to point to the new image3. reload the router. Some things that you may want to conside...
Very difficult to say without further debugging, but one thing that does spring to mind is the management VRF on the ASR. If you are using the Gig0 interface on the ASR, make sure that you have the config listed at:http://www.cisco.com/en/US/docs/rou...
If you are asking about the SNMP OID's I cannot say what they may be. However, from the IOS CLI the way to monitor the memory is to use the command:show platform software status control-processor briefThis will give you the breakdown of what is actua...
Hi Ratheesh,The line 4275009K/6147K bytes of memory is the amount of memory that IOS is allocated when it boots up.The line 8388608K bytes of physical memory is the amount of memory installed in the the RP of the router.The difference between the phy...
1. The ESP will do the fragmenting2. L2TPv3 is done in the ESP.The ASR1k does not forward any IP packets through the RP. It is either done in the ESP or it is not supportted.For the L2TPv3 case, the packets are received from the SPA, the L2TPv3 heade...