Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi If netflow is enabled on 1 interface, does this measure input/incoming flows only?my questions is if i need to measure the total traffic between 2 hosts behind 2 routers across a wan link . Do i need to enable netflow on both routers ?example enab...
HiIs the Netflow captures one way traffic. For example if i need to capture trafficfrom a host connected to a flow enabled router can this capture both way traffic?The problem is when we fix a equipment (packeteer) to the same network and monitor the...
Hi I have 2 questions.1. How do i identify by cisco commands there is a vlan overlapping , which creates one big broadcast stormis it debug commands?? can i identify from both L3 and L2 2. How do i troubleshhoot such a condition and find out where ex...
hi , is it possible to configure similar to the IOS the login local in which it prompts for the user name and password on the catalyst L2.I ma using a 6509
hi , is it possible to configure similar to the IOS the login local in which it prompts for the user name and password on the catalyst L2.I ma using a 6509
Hi All Thanks for the information.BTW if the source and destination is between more than 2 routers , is it sufficient to enable on both ethernet interfaces where the source ,destination belongs?or do i need to enable on the path to the destination ??
