Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a couple of PIX 525's in failover mode and it seems I consistantly have about a 1 percent packet loss to or through the inside interface.They are forced to 100 FULL on each end, connected to a Catalyst 6509 and set port host has been configure...
I currently have a Catalyst 4006 configured with an L3 module doing Inter-VLAN routing.There are two Gig ports in the Supervisor currently being used as Trunks.There are also two Gig ports in the L3 module itself and I want to use those ports to conn...
Please help me!I have looked over & over that the formula to configure CAR & it still makes no sense.Can someone please explain this too me?normal burst = configured rate * (1 byte)/(8 bits) * 1.5 secondsextended burst = 2 * normal burstIs the config...
I would also like to note that I have replaced cables and changed the switch ports (and blade) that the PIX interfaces were plugged into.This problem also seems to follow the active PIX making me think it must have something to do with the traffic be...
Thanks for all the advice, but I do understand how it works.What I want to know is what to make of the formula that I posted.This is Ciscos recommendation & is right on the doc CD.
