About Richard-Twickenham

Richard-Twickenham · 06-14-2018

I have struggled with this for quite some time and would be very grateful for some help. I have a Cisco 867 firewall installed in a branch office, connected between the office network and the local Internet connection. I have two IPSec tunnels bet...

Richard-Twickenham · 07-04-2017

I am trying to get a Cisco 867 working for a branch office scenario. It is just in a test environment at present, but I plan to use if for a real office once I get the configuration right. It is connected to an ADSL line which gives it an Internet ...

Richard-Twickenham · 06-22-2018

Hi dkilpatrick1, your suggestion works. It is a bit of nuisance to have to remember to add the source to the command - but I can live with that. I'm thinking of changing the configuration and to try a virtual interface for the tunnel. This may also...

Richard-Twickenham · 07-14-2017

Thanks Georg. Your suggestions once again pointed me in the right direction. The reason I put in the tunnel interface was so that I could make the tunnel the default route. I realise now that this is not necissary. I now understand that I just nee...

Richard-Twickenham · 07-11-2017

Thanks for your suggestions Georg. I've continued to work on this configuration whenever I had a chance over the last few days, but I have still not managed to get it working. I followed your suggestion to remove the NAT statements. I found that b...

Member Since	‎07-04-2017 07:33 AM
Date Last Visited	‎06-27-2018 12:18 AM
Posts	5

User Statistics

User Activity

Locally generated traffic not routing correctly

Help needed changing a split tunnel into a non-split tunnel

Re: Locally generated traffic not routing correctly

Thanks Georg. Your

Thanks for your suggestions